GEL or Flooded: What Actually Fails on a Boat or a Camper
Three swollen GEL blocks came back ten months after delivery, and the batteries had done nothing wrong. A 14.6 V alternator, a controller with no temperature sensor and two banks wired in parallel will kill any sealed battery. Here is what GEL tolerates, what it does not, and the eight lines that belong on the quotation.

A camper van converter ordered forty GEL blocks last spring. Ten months later three came back, swollen, terminals still shiny, cases bulging at the ends. The customer's message was one line: your batteries failed.
They had not failed. They had been cooked. The van had a "smart" alternator charging at 14.6 V for six hours on every drive, a solar controller with no temperature sensor, and a start battery wired straight across the house bank. Three ways to overcharge a sealed battery, and the van had all three.
This is the part nobody puts in the brochure. GEL and flooded lead-acid are not two grades of the same thing. They are two different sets of rules about who controls the voltage, and in a boat or a camper, nobody is controlling anything.
The question is not which chemistry is better
Ask a distributor in France or Spain what their marine customers want and you will hear GEL. Ask why, and the answer is usually "it lasts longer" or "it is maintenance free". Both are true, and both are only true if the charging system behaves.
Here is the honest version of the comparison. Same 12 V 100 Ah block, same shelf, different rules.
| Flooded deep cycle | AGM deep cycle | GEL deep cycle | |
|---|---|---|---|
| Charge voltage, cyclic use | 14.4–14.8 V (2.40–2.47 V/cell) | 14.4–14.7 V | 14.1–14.4 V |
| Float | 13.2–13.5 V | 13.5–13.8 V | 13.5–13.8 V |
| Water loss | Real, needs topping up | Very low, sealed | None, sealed |
| Overcharge tolerance | High — you can boil it and add water back | Moderate | Low — dries out, no way back |
| Partial state of charge tolerance | Good | Moderate | Poor |
| Cycle life at 50% DoD | 500–800 | 400–700 | 500–900 |
| Mounting position | Upright only | Any, except upside down | Any, except upside down |
| Cost per kWh | Lowest | Mid | Highest |
Read the third and fifth rows together and you have the whole story. GEL gives you more cycles and no maintenance, and in exchange it takes away your margin for error. Flooded will forgive a bad charger. GEL will not.
Which one your customer should buy depends on one thing: whether the voltage on that boat is ever going to be right. If there is a proper regulator with a temperature sensor and a charging profile that knows the difference between bulk and float, GEL is the better product and it will outlive the boat's second owner. If the charging is a 2005 alternator and a PWM controller from a hardware shop, GEL is the most expensive way to fail.
Three ways a boat or a camper kills GEL
You would be surprised how often it is all three at once. I have seen it enough times to check for these before anything else.
The alternator runs at 14.6 V for hours. That is 2.43 V per cell, which is equalise voltage, not float voltage. Twenty minutes of that after a deep discharge is fine and even useful. Six hours of it, three times a week, on a sealed battery with no way to lose water, is a slow bake. The electrolyte dries, the internal resistance climbs, and one hot day the case bulges. The battery did exactly what the physics said it would.
The solar controller has no temperature compensation. A controller set for 25 °C keeps pushing 14.4 V at 45 °C in the shade of a van roof. Our own maintenance numbers say to drop the voltage 3 mV per cell for every degree above 25 °C. That is 18 mV per 12 V block per degree, or roughly 0.36 V too much at 45 °C. Multiply that by a Greek summer and you have a battery that spends four months a year being overcharged.
The start battery and the house bank are wired together. This one looks harmless and is the most common. Two batteries of different age, different capacity and different chemistry, permanently in parallel, with a single alternator feeding both. The start battery is always full, the house bank is always hungry, and the alternator sees the average. The house bank never reaches absorption properly, and the start battery sits at a voltage it does not need. Fit a DC-DC charger or a proper relay. It costs less than one returned battery.
You can see why a distributor gets returns. The failure arrives nine to fourteen months later, the customer is sure the product is bad, and the actual cause is a wiring decision nobody wrote down.
Boats always under-buy, and the maths is simple
The other half of the returns are not electrical at all. They are a sizing mistake that the customer made in the showroom and that the installer did not correct.
A 7 m boat with a fridge, a plotter, LED lights and an anchor windlass draws maybe 60 Ah a day. The owner wants "two days of autonomy" and buys 200 Ah. Sounds right. Now apply the same derating we use everywhere else: usable depth of discharge 50% for GEL, a discharge rate closer to C5 than C20 on the windlass, and 35 °C in an engine bay.
| On paper | What the site actually gets | |
|---|---|---|
| Nameplate | 200 Ah | 200 Ah |
| Usable at 50% DoD | 100 Ah | 100 Ah |
| At C5 instead of C20 | — | ~85 Ah |
| At 35 °C ambient, life not capacity | — | capacity holds, life halves |
| Round-trip through an inverter at 0.85 | — | ~72 Ah usable AC |
Sixty amp-hours a day against seventy-two usable is not two days of autonomy. It is one day and a bit, and the owner will run it flat the first cloudy weekend. Deep discharge on a GEL block is survivable once, twice, ten times. It is not survivable as a habit, and that is the second most common return reason after overcharging.
If you want the full derating maths, it is in [why the invoice capacity is not usable capacity](/news/battery-bank-sizing-mistakes). The short version for a quote: take the daily load in Ah, divide by 0.5 for DoD, divide by 0.85 for the discharge rate, and add 20% for ageing. Then round up to the next size you actually stock.
What to put on the quotation
A quotation that protects you against the return looks like this, and it takes ten minutes to write.
| Line on the quote | Why it saves you money later |
|---|---|
| Chemistry and model, not just "100 Ah" | The customer cannot claim they were sold AGM when they paid for GEL |
| Charge voltage window for cyclic and float | Puts the installer on notice that the alternator matters |
| Maximum charge current (0.25C typical) | Stops someone fitting a 60 A charger to a 100 Ah block |
| Temperature compensation note | Shifts the blame to the controller, where it belongs |
| Recommended DoD and autonomy at that DoD | Kills the "it only lasted a day" argument before it starts |
| Storage and recharge interval before installation | Covers you if the block sat in a garage for eight months |
| What is excluded: overcharge, reverse polarity, physical damage | The three claims you will actually receive |
That last line is the one nobody wants to write and everybody needs. If a customer returns a swollen block with 15.9 V in its history, you need something in writing that says overcharging is not a manufacturing defect. Our own warranty position is on the [quality page](/quality), and it is deliberately narrow on abuse for exactly this reason.
So which one do you sell them
If the boat or van has a programmable charger with a temperature sensor, sell GEL and charge for it. It is the better long-term product and the customer will not come back for eight years.
If the installation is a 2005 alternator, a PWM controller and two batteries in parallel, sell AGM. It tolerates more abuse, it is cheaper, and when it dies in year four nobody is surprised.
If the customer insists on GEL with that installation, sell it — and write the charge voltage window on the invoice. Not to be difficult. Because in eleven months you will be looking at a photograph of a swollen case and a message that says your batteries failed, and the only thing that will settle the argument is a number you wrote down at the start.
We have both chemistries on the same line, so this is not a pitch for one of them. It is the conversation we have with distributors before the first order, because it is much cheaper to have it now than after the container clears customs.
Looking for a reliable battery supplier?
Send us your requirements — model, quantity and target market. Quote within 24 hours.
Get a Quote